Bright Red Spark Plug Wires
- FITS: 02-07
- Exceeds the stock wire specs
- No modifications needed to install
- Sets your bike apart from the others!
These wires are made with high quality Taylor 8mm coated, silicone spiral core ignition wire.
Compliment or contrast your paint scheme with some color!
They have smaller diameter spark plug boots to make it easier to grasp when removing the plug from down in the head.
They are designed to be the perfect length to show them off without the need to tie them to your frame. They can be used with or without triangular chrome side
covers for coil and ignition (cheese wedges)
Frequently Asked Questions:
Will the wires make more power?
You probably won't notice it unless you have had engine work done or if you put your bike on a dyno. Only then will the benefits of the 8mm Taylor wires be noticed. They are more for looks, put they do perform better than the stock wires.
Do I need to modify anything to get them to fit?
These are direct replacements and these actually fit better than stock as the plug boots are smaller and easier to remove. The old wires were zip tied to the frame where these ones do not need to be. You want these to hang down some to be seen. TrikWires are made to specific lengths to ensure a nice fit. Some people have made small clearance notches in the back side of thier chrome triangular "cheese wedge" covers. This is not needed but some wanted to do this. You can run your bike without the cheese wedges for an even better look if so desired...
What bikes will they fit?
These wires will fit 2002 and newer Victory bikes with the newer style "Freedom" engine. All models are included except the older engined bikes. I have tried to make wires for the older 99-02 Victory bikes with the "Hammer" engine with no luck. It seems Victory used a few different coil connector types and the boot into the top of the head is very expensive. I will not be making any of these wires for the older bikes. Additionally I make Victory Vision wires too, but these may take slightly longer due to different coil boots and connectors.
How do I take care of the wires?
The solid colored wires are made of high temp silicone and only need a wipe. I heat shrink my braided wires with a new crystal clear heat shrink that will not haze. I would recommend wiping the wires off if any fuel or oil gets on them to keep them looking thier best, but they will resist most chemicals and heat.
